Joined in 2023 
82 
63 About this deal
In terms of safety, I have no complaints at all with the Wasabi branded batteries. They don’t last as long as the Fujifilm, but they are consistent and the camera functions perfectly with them. The Dot-01 brand though, I do have concerns with and would not recommend. They get excessively hot when used for a whole shoot, and as I noted above, they (or at least the few that I have) have ceased to go in and out of the camera as smoothly as they should. It could be the two that I have, but they are the newest batteries in my kit, and they should not be doing this. The battery indicators in cameras are based on actual voltage of the battery. However, since the Fuji batteries have quite a different voltage curve, compared to all the aftermarket batteries, the remaining capacity shown by the camera isn’t accurate for non-Fuji batteries. This is mostly apparent on almost empty batteries — while the camera shows that the battery is still OK, it can actually be almost empty. However, not all third party batteries work as well as PATONA/WATSON. As tested, and we reported here, some third party batteries are so bad, that some called them to be a “fraud“. NP-W126S Third Party HS50EXR HS30EXR HS33EXR Will this battery have any safety risks? What is the quality of the Fujifilm NP-W126S compatible battery?
Note: Battery endurance varies with battery charge level and the figures given above are not guaranteed. Battery endurance will decline at low temperatures. in., 3690k-dot OLED viewfinder; magnification 0.75× with 50 mm lens (35 mm format equivalent) at infinity and diopter set to −1.0 m−1; diagonal angle of view approximately 38° (horizontal angle of view approximately 30°) If you want the ultimate performance or you do a lot of 4K video recording or continuous shooting, NP-W126S is clearly the winner. That said, some of the third party batteries are very close to the Fujifilm’s original in performance, while they cost only a fraction of the price. First, though, it is important to note that it is not recommended that you use third-party batteries with your camera. They are not held up to the high standards that OEM batteries are and they CAN damage your camera – even kill it. So it goes without saying, if you use them, you use them at your own risk.
Our Contact Details
The frame rate and number of frames per burst varies with shooting conditions and type of memory card used. Movies: Standard output sensitivity equivalent to ISO 160 – 12800 in increments of 1/3 EV; AUTO; extended output sensitivity equivalent to ISO 25600 Please complete the form below for a quote - Please be as accurate as possible to help us give an accurate quote. Well, that's a piece of information I've not seen. Where did you read that about the X-Pro2 design? B&H lists compatibility for the battery as: X-T2 and X-Pro2. Why do they identify these two as fully compatible but not the X-T1 and earlier x models? You must have sources that say B&H got it wrong. I'm genuinely curious.
Cameras – LCD screen is heavily worn either by de-lamination or has scratches to it. Rubber grips are starting to come away from the body. Autofocus system: Intelligent hybrid AF (TTL contrast-detect/phase-detection AF) with AF-assist illuminator Still pictures: Exif 2.3 JPEG (compressed); RAW (original RAF format, uncompressed or compressed using a lossless algorithm; special purpose software required); RAW+JPEG available My old original NP-W126 currently, after several years of usage, has roughly 1100 mAh, while it had >1200 mAh when new. Lower quality batteries can show more significant aging, the DSTE battery is already almost unusable. ConclusionI had one fully charged, put it into my X-Pro2, shot for maybe 10 minutes, and then the camera shut down. I was so confused. I popped the battery out, it was hot, and popped in a Wasabi battery and let the camera sit for a minute to cool. Turned it on and all was well – thank goodness. But needless to say, I won’t be buying anymore dirt cheap Dot-01 batteries. This battery is made of top materials of Lithiumion cells that have been safely certified by RoHS, CE, FCC and tested through repeated simulated work and commissioning before they are shipped from the factory. On the other hand, its specifications are based on the original standards such as appearance, interface type, body size, capacity, voltage, charging current and voltage, etc. Is it real Fujifilm NP-W126S compatibility information? This product information is fully applicable to the Fujifilm series compatible batteries, "Fujifilm battery NP-W126S". I haven’t done any rigorous testing in this area, so far I’ve just tried to put all the brands to a fridge for few days, but haven’t measured any significant loss of charge. Even when not used for a long period, none of my batteries suffered any significant discharge. Battery aging I also used my thermal camera, Flir One for Android ( iOS version exists too), to capture batteries after a heavy load. While the original battery shows mostly evenly distributed heat on its surface, the noname battery has much higher temperature in a smaller rectangle in the middle. This might be the reason for swelling of some batteries. Self-discharging
Submit a valuation request and we'll provide guide prices with no delay. Plus, we'll collect your gear from your home or work for FREE. Apparently the cheapest aftermarket batteries fail pretty bad, but fortunately many brands offer pretty solid competitors to the original batteries. They often have almost the same capacities and also heat management under a heavy load seems to be alright. Watson and Green Extreme have performance pretty much on par with the original batteries and cost roughly a third of them. They are currently available only the US. The original Fujifilm’s batteries for X system camera are expensive. That’s the reason why there are so many alternatives available, but it also makes the choice of the right one tough. They not only vary in price and capacity, but some 3rd party batteries can even swell in camera and potentially damage it. This article tries to help with the right choice due to extensive testing of capacities and heat characteristics of several available brands. NP-W126SStill pictures: Standard output sensitivity equivalent to ISO 160 – 12800 in increments of 1/3 EV; AUTO; extended output sensitivity equivalent to ISO 80, 100, 125, 25600, or 51200 Our used products are subject to wear and tear in comparison to brand new products. This also applies to accessories that are supplied with the camera including batteries which may have a lower optimum performance level/life expectancy. This issue isn’t that serious on new Fuji cameras (like X-T2 or X-Pro2) since their indicator is more granular and even percentage can be shown. Older cameras (X-T1 or X-Pro1) offer only 4 states of the indicator (Full or 3 bars, 2 bars, 1 bar and Empty). Based on the chart we can deduct how much of the battery remains when there is a change in the battery indicator: In short, I don’t trust them. That said. I wanted to share my experience with these two third-party batteries compared to each other as well as to my original NP-W126 battery from Fujifilm. Run Time
mm × 92.8 mm × 58.8 mm (35.4 mm excluding projections, measured at thinnest part)/5.22 in. × 3.65 in. × 2.31 in. (1.39 in.) It makes more sense to me that Fuji would have designed both of the Generation 3 cameras to take full advantage of the new battery they were developing, but that the battery might not have been ready for the X-Pro2 release. Today I received 2 batteries and they are working perfect in my booster grip (without the camera internal battery)“Looking to upgrade your equipment? Get competitive prices on major brands with our part-exchange service. MHz (11 channels) in the case of the X-T3 WW. EF‑X8 shoe-mounted flash unit (not included with the X-T3 WW) Guide number Auto, Custom 1, Custom 2, Custom 3, color temperature selection, direct sunlight, shade, daylight fluorescent, warm white fluorescent, cool white fluorescent, incandescent, underwater In Europe, there are very good Patona Platinum, Patona Premium and ExPro White. All of them offer >90% capacity of the original batteries and also they don’t seem to produce significantly more heat even after some heavy use. Lenses – Should have no marks on the elements andoptically clear. There may be light dust present that will not effect theimagery.
Great Deal 
New Comment